Teledyne-lecroy QPHY-DDR4 Manual de usuario descargar pdf (Pagina 37)

QPHY-DDR4 Software Option

• tERR(3 per) fall (P8) is the TIE measure at Vref (0 mV) of Z1 (differential clock signal) on only the

falling edges (negative pulses). It is set up to measure edges at intervals of 3. The minimum

value is measured as tERR(3per)fall, min reported in mUI and the maximum value is measured

as tERR(3per)fall, max reported in mUI.

• tERR(4 per) r (P9) is the TIE measure at Vref (0 mV) of Z1 (differential clock signal) on only the

rising edges (positive pulses). It is set up to measure edges at intervals of 4. The minimum value

is measured as tERR(4per)rise, min reported in mUI and the maximum value is measured as

tERR(4per)rise, max reported in mUI.

• tERR(4 per) fall (P10) is the TIE measure at Vref (0 mV) of Z1 (differential clock signal) on only the

falling edges (negative pulses). It is set up to measure edges at intervals of 4. The minimum

value is measured as tERR(4per)fall, min reported in mUI and the maximum value is measured

as tERR(4per)fall, max reported in mUI.

• tERR(5 per) r (P11) is the TIE measure at Vref (0 mV) of Z1 (differential clock signal) on only the

rising edges (positive pulses). It is set up to measure edges at intervals of 5. The minimum value

is measured as tERR(5per)rise, min reported in mUI and the maximum value is measured as

tERR(5per)rise, max reported in mUI.

• tERR(5 per) fall (P12) is the TIE measure at Vref (0 mV) of Z1 (differential clock signal) on only the

falling edges (negative pulses). It is set up to measure edges at intervals of 5. The minimum

value is measured as tERR(5per)fall, min reported in mUI and the maximum value is measured

as tERR(5per)fall, max reported in mUI.

924291 Rev A 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 72 73

Sin comentarios

Teledyne-lecroy QPHY-DDR4 Manual de usuario Pagina 37