Teledyne-lecroy QPHY-LPDDR2 Manual de usuario descargar pdf (Pagina 48)

QPHY-LPDDR2-OM-G Rev B

Figure 27. Slew Rate [JESD209-2D figure 124]

DQS and DQS# signals must be monotonic between VIL(dc)max and VIH(dc)min.

Hold (tDH) nominal slew rate for a rising signal is defined as the slew rate between the last crossing of

VIL(dc)max and the first crossing of VREF(dc). Hold (tDH) nominal slew rate for a falling signal is defined

as the slew rate between the last crossing of VIH(dc)min and the first crossing of VREF(dc).

tIS(base) - Address and Control Input Setup Time

Input waveform timing is referenced from the input signal crossing at the VIH(ac)min level to the

differential clock crosspoint at VREF for a rising signal, and from the input signal crossing at the

VIL(ac)max level to the differential clock crosspoint at VREF for a falling signal applied to the device

under test. See table below.

1 2 ... 43 44 45 46 47 48 49

Sin comentarios

Teledyne-lecroy QPHY-LPDDR2 Manual de usuario Pagina 48